Project

General

Profile

Actions

tickets #76909

closed

My camera does not work on meet2.opensuse.org, but works on meet.opensuse.org

Added by robin_listas over 3 years ago. Updated about 3 years ago.

Status:
Resolved
Priority:
Normal
Assignee:
Category:
-
Target version:
-
Start date:
2020-11-03
Due date:
% Done:

0%

Estimated time:

Description

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

I found on the previous heroes meeting that my camera would not work, on
two different laptops, on the meet2 platform, while it works on the meet
platform.

Per suggests that issue might be a jitsi setting that demands a minimum
vertical resolution.

Laptop 1: CPU goes 100% and sound stutters. The meet system refuses the
internal camera, "camera does not support required video resolution".

Laptop 2: CPU goes 90%, so it copes (barely), but the meet system refuses
my camera, "camera does not support required video resolution".

On both laptops, the camera is recognized and works in "setup", but not on
the actual session.

https://test.webrtc.org report:

Laptop 2. Microphone passes. Camera passes at 320*240, gets stuck at
640*480. Prints a small progress green line that stops at the end where it
should say "ok". Doesn't do any more testing. Cpu load is 8 by pulse
audio. Camera led is now off.

Laptop-1 on wifi.

Camera fails at 1280*720,
network warning at ipv6,
connectivity warning because "reflexive connectivity"
video bandwidth throughput fails.

Laptop-1 on eth.

gets stuck when testing camera at 640*480, same as laptop-2

Restarting the test passes that point:

Camera fails at 1280*720,
network warning at ipv6,
connectivity warning because "reflexive connectivity"
video bandwidth throughput fails.

No improvement.

Video throughput says it failed because "frame rate mean is 0, can not
test bandwidth without a working camera".

Retesting laptop-2

Laptop 2. Microphone passes. Camera fails at 1280*720.
Network warning, no ipv6.
Video thorughput fails, same problem as laptop-1

Laptop 1 says on https://test.webrtc.org/, camera section:

Check resolution 320x240 yes
Check resolution 640x480 yes
Check resolution 1280x720 no
Check supported resolutions yes
[ OK ] Supported: 160x120
[ OK ] Supported: 160x120
[ INFO ] 320x180 not supported
[ OK ] Supported: 320x240
[ INFO ] 640x360 not supported
[ OK ] Supported: 640x480
[ INFO ] 768x576 not supported
[ INFO ] 1024x576 not supported
[ INFO ] 1280x720 not supported
[ INFO ] 1280x768 not supported
[ INFO ] 1280x800 not supported
[ INFO ] 1920x1080 not supported
[ INFO ] 1920x1200 not supported
[ INFO ] 3840x2160 not supported
[ INFO ] 4096x2160 not supported

Legolas:~ # hwinfo --camera
Legolas:~ #
Legolas:~ # hwinfo --usb
...
03: USB 00.1: 0000 Unclassified device
[Created at usb.122]
Unique ID: NwzV.qgJNtqgvqj2
Parent ID: k4bc.2DFUsyrieMD
SysFS ID: /devices/pci0000:00/0000:00:14.0/usb1/1-5/1-5:1.1
SysFS BusID: 1-5:1.1
Hardware Class: unknown
Model: "Acer Lenovo EasyCamera"
Hotplug: USB
Vendor: usb 0x5986 "Acer, Inc"
Device: usb 0x0673 "Lenovo EasyCamera"
Revision: "42.08"
Serial ID: "200901010001"
Driver: "uvcvideo"
Driver Modules: "uvcvideo"
Speed: 480 Mbps
Module Alias: "usb:v5986p0673d4208dcEFdsc02dp01ic0Eisc02ip00in01"
Config Status: cfg=new, avail=yes, need=no, active=unknown
Attached to: #4 (Hub)

Laptop 2 says on https://test.webrtc.org/, camera section:

Check resolution 320x240 Ok
Check resolution 640x480 Ok
Check resolution 1280x720 no
Check supported resolutions Ok
[ OK ] Supported: 160x120
[ OK ] Supported: 160x120
[ INFO ] 320x180 not supported
[ OK ] Supported: 320x240
[ INFO ] 640x360 not supported
[ OK ] Supported: 640x480
[ INFO ] 768x576 not supported
[ INFO ] 1024x576 not supported
[ INFO ] 1280x720 not supported
[ INFO ] 1280x768 not supported
[ INFO ] 1280x800 not supported
[ INFO ] 1920x1080 not supported
[ INFO ] 1920x1200 not supported
[ INFO ] 3840x2160 not supported
[ INFO ] 4096x2160 not supported

minas-tirith:~ # hwinfo --camera
minas-tirith:~ # hwinfo --usb
...
04: USB 00.0: 0000 Unclassified device
[Created at usb.122]
Unique ID: +4pb.ZsZeIl28cM9
Parent ID: FZIx.9T1GDCLyFd9
SysFS ID: /devices/pci0000:00/0000:00:1d.7/usb8/8-4/8-4:1.0
SysFS BusID: 8-4:1.0
Hardware Class: unknown
Model: "Quanta HP Webcam-101"
Hotplug: USB
Vendor: usb 0x0408 "Quanta Computer, Inc."
Device: usb 0x0f41 "HP Webcam-101"
Revision: "1.03"
Serial ID: "QCM"
Driver: "uvcvideo"
Driver Modules: "uvcvideo"
Device File: /dev/input/event13
Device Files: /dev/input/event13,
/dev/input/by-id/usb-SN001_HP_Webcam-101_QCM-event-if00,
/dev/input/by-path/pci-0000:00:1d.7-usb-0:4:1.0-event
Device Number: char 13:77
Speed: 480 Mbps
Module Alias: "usb:v0408p0F41d0103dcEFdsc02dp01ic0Eisc01ip00in00"
Driver Info #0:
Driver Status: uvcvideo is active
Driver Activation Cmd: "modprobe uvcvideo"
Config Status: cfg=new, avail=yes, need=no, active=unknown
Attached to: #3 (Hub)


Cheers / Saludos,

Carlos E. R.
(from 15.1 x86_64 at Legolas)
-----BEGIN PGP SIGNATURE-----

iHYEARECADYWIQQZEb51mJKK1KpcU/W1MxgcbY1H1QUCX6FCrhgcY2FybG9zLmUu
ckBvcGVuc3VzZS5vcmcACgkQtTMYHG2NR9VYMACgkUy7aJKbxz7DhNqE4nJYqcOX
2ocAoIcV3zSqylBJ2nn0cEViSFej2FbM
=RNPm
-----END PGP SIGNATURE-----

Actions

Also available in: Atom PDF